Digital Photography

Radio controlled toys - Help

The most important step in flying a R.C. Helicopter is the setup. If your helicopter is not setup right the bird will tip side to side, frontward or backward, or the tail could spin out of control. You can see the importance of a good setup.

1. The first step in setting up a R.C. Helicopter.

· Make sure all servos are moving in the right direction When you move the right side stick right the swash plate will tilt right etc for forward and back.
· Make sure the throttle is correct and the it does not need reversed in the radio also called the TX.

2. Now that the servos are moving in the right direction we need to center the servos.

· Turn on radio then plug in receiver make sure the motor is unplugged if working on electric helicopter.
· Move the throttle stick to half way this get all your servos to the half way position.
· Now we want to find the servo horn that will line up 90 degrees with center keep moving till you find one that is close or dead on make sure to put in the screw when you find the one that works.

HX RADIO CONTROL HELICOPTER

Read the rest of this entry »

Radio controlled toys: The first general use of radio control systems in models started in the early 1950s with single-channel self-built equipment; commercial equipment came later. The advent of transistors greatly reduced the battery requirements, since the current requirements at low voltage were greatly reduced and the high voltage battery was eliminated. In both tube and early transistor sets the model’s control surfaces were usually operated by an electromagnetic escapement controlling the stored energy in a rubber-band loop, allowing simple on/off rudder control (right, left, and neutral) and sometimes other functions such as motor speed.[1]

Crystal-controlled superheterodyne receivers with better selectivity and stability made control equipment more capable and at lower cost. Multi-channel developments were of particular use to aircraft, which really needed a minimum of three control dimensions, (yaw, pitch and motor speed) as opposed to boats, which can get away with two or one.

Read the rest of this entry »

Radio controlled toys are out.  Outdoors that is.  There is water to sail the controlled ships in.

The first general use of radio control systems in models started in the early 1950s with single-channel self-built equipment; commercial equipment came later. The advent of transistors greatly reduced the battery requirements, since the current requirements at low voltage were greatly reduced and the high voltage battery was eliminated. In both tube and early transistor sets the model’s control surfaces were usually operated by an electromagnetic escapement controlling the stored energy in a rubber-band loop, allowing simple on/off rudder control (right, left, and neutral) and sometimes other functions such as motor speed.[1]

Crystal-controlled superheterodyne receivers with better selectivity and stability made control equipment more capable and at lower cost. Multi-channel developments were of particular use to aircraft, which really needed a minimum of three control dimensions, (yaw, pitch and motor speed) as opposed to boats, which can get away with two or one.

Silerlit pirateship

Radio control?  What a variety there is for radio controlled toys.  Control for the toys is not difficult.  Some of the favorites remain - the airplanes.

A little information: Remote control military applications are typically not radio control in the direct sense, directly operating flight control surfaces and propulsion power settings, but instead take the form of instructions sent to a completely autonomous, computerized automatic pilot. Instead of a “turn left” signal that is applied until the aircraft is flying in the right direction, the system sends a single instruction that says “fly to this point”.

Some of the most outstanding examples of remote radio control of a vehicle are the Mars Exploration Rovers such as Sojourner.

silverlit-palmz 2 - miniature radio controlled airplane

It’s great fun to play with the radio controlled toys.  Here’s a bit of history on radio control.                          Today radio control is used in industry for such devices as overhead cranes and switchyard locomotives. Radio-controlled teleoperators are used for such purposes as inspections, and special vehicles for disarming of bombs. Some remotely-controlled devices are loosely called robots, but are more properly categorized as teleoperators since they do not operate autonomously, but only under control of a human operator.

Remote control military applications are typically not radio control in the direct sense, directly operating flight control surfaces and propulsion power settings, but instead take the form of instructions sent to a completely autonomous, computerized automatic pilot. Instead of a “turn left” signal that is applied until the aircraft is flying in the right direction, the system sends a single instruction that says “fly to this point”.

Some of the most outstanding examples of remote radio control of a vehicle are the Mars Exploration Rovers such as Sojourner.

HX RADIO CONTROL HELICOPTER

Radio controlled toys are ever so popular. The first general use of radio control systems in models started in the early 1950s with single-channel self-built equipment; commercial equipment came later. The advent of transistors greatly reduced the battery requirements, since the current requirements at low voltage were greatly reduced and the high voltage battery was eliminated.

In both tube and early transistor sets the model’s control surfaces were usually operated by an electromagnetic escapement controlling the stored energy in a rubber-band loop, allowing simple on/off rudder control (right, left, and neutral). and sometimes other functions such as motor speed.[1]

EXCALIBUR® NASCAR 1:10TH SCALE RADIO CONTROL CAR

Read the rest of this entry »